Effect of sowing times and irrigation regimes on stomatal conductance and stomatal resistance in summer pearl millet

Authors

  • P. B. Pawar Department of Agronomy, Mahatma Phule Krushi Vidyapeeth, Rahuri, Dist-Ahermadnagar, Maharashtra Author
  • S. R. Patil Department of Agronomy, Mahatma Phule Krushi Vidyapeeth, Rahuri, Dist-Ahermadnagar, Maharashtra Author
  • A. S. Jadhav Department of Agronomy, Mahatma Phule Krushi Vidyapeeth, Rahuri, Dist-Ahermadnagar, Maharashtra Author

Keywords:

Pearl millet, Sowing times, Irrigation regimes, Stomatal conductance, Stomatal resistance

Abstract

This study was undertaken at Water Management Project farm, Mahatma Phule Krishi Vidyapeeth, Rahuri, Maharashtra (19.38°N latitude, 74.65ºE longitude and at height of 511 m above sea level) during summer season 2010 and 2011 to work out effect of different sowing times and irrigation regimes on stomatal conductance and stomatal resistance of summer pearl millet. There were 12 treatment combinations for experiment having four sowing times, viz., D1-6th MW (5-11 February), D2-8th MW (19-25 February), D3-10th MW (5-11 March) and D4-12th MW (19-25 March) and three irrigation regimes, viz., I1-100 mm CPE, I2-125 mm CPE and I3-150 mm CPE. A strip plot design was employed with three replications. The results revealed that higher rate of stomatal conductance was observed in early sown summer pearl millet (8th MW) (at 56 DAS- 0.45 mole m-2 s-1 in 2010 and 0.44 mole m-2 s-1 in 2011) as compared to late sown (12th MW) (at 56 DAS- 0.29 mole m- 2 s-1 in 2010 and 0.29 mole m-2 s-1 in 2011) while opposite results was obtained for stomatal resistance. It is also observed that stomatal conductance of leaves of pearl millet at flowering largely operates to maximize assimilation rather than to minimize water loss at 100 mm CPE (at 56 DAS- 0.44 mole m- 2 s-1 in 2010 and 0.43 mole m-2 s-1 in 2011) irrigation regime while, it operates reverse when sown late and irrigated at 150 mm CPE (at 56 DAS- 0.30 mole m-2 s-1 in 2010 and 0.30 mole m-2 s-1 in 2011) irrigation regime. Thus, from the results of the present investigation it can be concluded that summer pearl millet sown in 8th MW (19-25th February) and irrigated with 100 mm CPE irrigation regimes would be the best proportion for higher productivity and better monetary benefits by improving stomatal conductance.

Downloads

Published

2014-01-01

Issue

Section

Articles

How to Cite

Effect of sowing times and irrigation regimes on stomatal conductance and stomatal resistance in summer pearl millet. (2014). The Ecoscan, 301-305. https://theecoscan.org/index.php/ECOSCAN/article/view/98

Similar Articles

1-10 of 17

You may also start an advanced similarity search for this article.